Kia Sorento: Oil Pan Installation - Lubrication System - Engine Mechanical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Oil Pan Installation

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Lubrication System / Oil Pan Installation

1.
Install the oil pan.
(1)
Using a gasket scraper, remove all the old sealant material from the gasket surfaces.
(2)
Before assembling the oil pan, liquid sealant Loctite 5900H, Threebond 1217H or equivalent should be applied on oil pan. The part must be assembled within 5 minutes after sealant was applied.

Bead width : 3.0 mm (0.12 in.)

  
•
When applying sealant gasket, sealant must not be protruded into the inside of oil pan.
•
To prevent leakage of oil, apply sealant gasket on the inner threads of the bolt holes.
(3)
Install the oil pan (A). Uniformly tighten the bolts in several passes.

Tightening torque
Bolts B (M9) :
30.4 ~ 34.3 N.m (3.1 ~ 3.5 kgf.m, 22.4 ~ 25.3 lb-ft)
Bolts C (M6) :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

  
After assembly, wait at least 30 minutes before filling the engine with oil.
  
Always use a new drain plug gasket.
2.
Install the A/C compressor bracket (A).

Tightening torque :
19.6 ~ 23.5 N.m (2.0 ~ 2.4 kgf.m, 14.5 ~ 17.4 lb-ft)

3.
Install the A/C compressor lower bolts.
(Refer to Heating, Ventilation, Air Conditioning - "Compressor")
4.
Refill engine with engine oil.
Oil Pan Removal
1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the A/C compressor. (Refer to Heating, Ve ...

Balance Shaft & Oil Pump Components
1. Balance shaft & oil pump assembly 2. Balance shaft chain tensioner 3. Balance shaft chain 4. Balance shaft chain sprocket 5. Balance shaft chain guide 6. Balance shaft ...

See also:

Cooling Fan Description
Control the cooling motor voltage in according to the duty(300Hz) of ECM. [ECU → PWM Input Signal(SI : 300Hz)] Signal Input Duty (%) Motor Voltage (V) 10 ...

Description
Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications and the addition of special control components. Modifications to the combustion chamber, intake manifo ...

Mode Control Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the driver's side crash pad side cover. ...

Copyright © www.ksmanual.com 2014-2024