Kia Sorento: Thermostat Inspection - Cooling System - Engine Mechanical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Thermostat Inspection

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Cooling System / Thermostat Inspection

1.
Immerse the thermostat in water and gradually heat the water.

2.
Check the valve opening temperature.

Valve opening temperature: 82°C (177°F)
Full opening temperature: 95°C (205°F)

If the valve opening temperature is not as specified, replace the thermostat.
3.
Check the valve lift.

Valve lift : 8 mm (0.3 in) or more at 95°C (205°F)

If the valve lift is not as specified, replace the thermostat.
Thermostat Removal and Installation
   Removal of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the ther ...

Thermostat Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting bolts ...

See also:

Under Body (2WD)
Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual-Measurement Dimensions ...

Component Location
1. Driver power window main switch 2. Passenger window switch 3. IPM (Intalligent intergrated Platform Module) 4. Door lock switch 5. Tailgate lock actuator & switch ...

Antenna Coil Installation
1. Install the coil antenna and connect the 6P connector. 2. Install the steering column upper and lower shrouds. ...

Copyright © www.ksmanual.com 2014-2024