1. |
Remove the cooling fan (A) after loosening the screws (B) from the cooling
assembly.
|
2. |
Remove the fan motor (B) after loosening the screws (A) from the cooling
fan shround.
|
3. |
Install in the reverse order of removal.
|
Operation
Evaporative System Monitoring
Evaporative And ORVR Emission Control System
This system consists of below items;
-
Fill vent valve
-
F ...
Power Mosfet (DATC) Inspection
1.
Measure the resistance between the terminals.
2.
If the measured resistance is not within specification, the blower
resistor must be rep ...
Blind Spot Detection Switch Installation
1.
Install the crash pad side switch assembly after connecting the
connector.
2.
Install the crash pad lower panel.
...