Kia Sorento: Cylinder Block Reassembly - Cylinder Block - Engine Mechanical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Cylinder Block Reassembly

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Cylinder Block / Cylinder Block Reassembly

1.
Install the oil jet (A).

Tightening torque :
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)

2.
Install the crankshaft.
(Refer to Cylinder Block - "Crankshaft")
3.
Install the piston & connecting rod assembly.
(Refer to Cylinder Block - "Piston And Connecting Rod")
4.
Install the ladder frame.
(Refer to Cylinder Block - "Ladder Frame")
Cylinder Block Inspection
1. Remove gasket material. Using a gasket scraper, remove all the gasket material from the top surface of the cylinder block. 2. Cl ...

Piston and Connecting Rod Components
1. Piston ring 2. Snap ring 3. Piston 4. Connecting rod 5. Connecting rod upper bearing 6. Connecting rod lower bearing 7. Connecting rod bearing cap ...

See also:

Rear Upper Arm Inspection
1. Check the bushing for wear and deterioration. 2. Check the rear upper arm or damage and deformation. 3. ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV termi ...

IPM Components
Outer Connector (L / M / N / K) Connector Pin No. Description Active Remark K 1 IMS LIN     ...

Copyright В© www.ksmanual.com 2014-2024