Kia Sorento: Rear Oil Seal Installation - Cylinder Block - Engine Mechanical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Rear Oil Seal Installation

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Installation

1.
Install rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using SST(09231-H1100, 09214-2W200) (B) and a hammer, tap in the oil seal (A) until its surface is flush with the rear oil seal retainer edge.

2.
Install the drive plate.
(Refer to Cylinder Block - "Drive Plate")
3.
Install the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate. ...

Ladder Frame Removal
   • Use fender covers to avoid damaging painted surfaces. • ...

See also:

Rear Disc Brake Replacement
1. Remove the rear wheel & tire. 2. Loosen the guide rod bolt (B) and pivot the caliper (A) up out of the way. ...

Rearview camera (If equipped)
The rearview camera will activate with the ignition switch ON and the shift lever in the R (Reverse) position. This system is a supplemental system that shows behind the vehicle through the rearv ...

Tilting the sunroof
Before opening or closing the sunroof, open the roller blind (refer to the following page for instructions on how to use the roller blind). To open the sunroof, push the sunroof control lever upwa ...

Copyright © www.ksmanual.com 2014-2024