Kia Optima Manuals

Kia Sorento: Drive Plate Removal and Installation - Cylinder Block - Engine Mechanical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Drive Plate Removal and Installation

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Cylinder Block / Drive Plate Removal and Installation

1.
Remove the automatic transaxle .
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate (A) and the adapter plate (B).
Tightening torque :
117.7 ~ 127.5 N.m (12 ~ 13 kgf.m, 86.8 ~ 94.0 lb-ft)

  
•
Always use new drive plate (or flywheel) bolts.
•
Apply sealant to the screw part (10mm from the end of the bolt) when reusing the drive plate bolts.
Sealant: Three bond 2403, Loctite 200 or 204
•
Install and uniformly tighten the 7 bolts, in several passes.
3.
Install in the reverse order of removal.
Components
1. Piston ring 2. Snap ring 3. Piston 4. Connecting rod 5. Connecting rod upper bearing 6. Piston pin 7. Connecting rod lower bearing 8. Connecting rod bearing cap ...

Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate. ...

See also:

Front Seat Belt Replacement
Front Seat Belt Replacement    • When installing the belt, make sure not to damaged the ...

Compressor Oil Specification
1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. ...

Oil hydraulic Motor(Actuator) Removal
1. Remove the coupling assembly. (Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator Coupling") 2. Keep goin ...

Categories


Copyright © www.ksmanual.com 2014-2024