1. |
For release the tension, turn the drive belt tensioner counterclockwise
then remove the drive belt (A).
|
2. |
Install the drive belt (A).
Rotate the drive belt tensioner arm (A) counterclockwise moving the
tensioner pulley bolt with wrench. After putting the belt on the tensioner
pulley, release the tensioner pulley slowly.
Crankshaft pulley → A/C pulley → Alternator pulley → Idler #1 pulley
→ Idler #2 pulley → Water pump pulley → Tensioner pulley.
|
Warning lights
✽ NOTICE - Warning lights
Make sure that all warning lights are OFF after starting the engine. If any
light is still ON, this indicates a situation that needs attention.
Air bag Warning Ligh ...
Hazard Lamp Switch Installation
1.
Install the heater control unit to the center fascia panel.
2.
Install the center fascia panel.
...
Rear Differential Carrier Removal
1.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...