• |
Adjust a shift cable.
|
• |
Refill engine with engine oil.
|
• |
Refill a transaxle with fluid.
|
• |
Refill power steering fluid.
|
• |
Refill a radiator and a reservoir tank with engine coolant.
|
• |
Place a heater control knob on "HOT" position.
|
• |
Clean battery posts and cable terminals and assemble.
|
• |
Inspect for fuel leakage.
|
- |
After assemble the fuel line, turn on the ignition switch (do not operate
the starter) so that the fuel pump runs for approximately two seconds
and fuel line pressurizes.
|
- |
Repeat this operation two or three times, then check for fuel leakage
at any point in the fuel line.
|
• |
Bleed air from the cooling system.
|
- |
Start engine and let it run until it warms up. (until the radiator fan
operates 3 or 4 times.)
|
- |
Turn Off the engine. Check the level in the radiator, add coolant if
needed. This will allow trapped air to be removed from the cooling system.
|
Circuit Diagram
...
Vehicle weight glossary
This section will guide you in the proper loading of your vehicle and/or trailer,
to keep your loaded vehicle weight within its design rating capability, with or
without a trailer.
Properly loading ...
Front seat adjustment - power (if equipped)
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion.
Before driving, adjust the seat to the proper position so you can easily control
the steerin ...