If the there is lack of power, excessive oil consumption or poor fuel
economy, measure the compression pressure.
|
1. |
Warm up and stop engine.
Allow the engine to warm up to normal operating temperature.
|
2. |
Disconnect the injector extension connector (A) and ignition coil connectors
(B).
|
3. |
Remove ignition coils (A).
|
4. |
Remove spark plugs.
Using a 16mm plug wrench, remove the 4 spark plugs.
|
5. |
Check cylinder compression pressure.
|
6. |
Reinstall spark plugs.
|
7. |
Install ignition coils.
|
8. |
Connect the injector extension connector and ignition coil connectors.
|
9. |
Some DTC's may exist after the inspection test and may need to be manually
cleared with GDS.
|
Vehicle handling instructions
As with other vehicles of this type, failure to operate this vehicle correctly
may result in loss of control, an accident or vehicle rollover.
Specific design characteristics (higher ground clearanc ...
Panoramic sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof
with the sunroof control lever located on the overhead console (1).
The sunroof can only be opened, closed, or tilted ...
4WD ECU Removal
1.
Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing
with the GDS tool.
(Refer to 4WD Control System - "Repair procedures")
...