1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear luggage side trim.
(Refer to Body - "Interior Trim")
|
3. |
Remove the rear blower resistor (A) after loosening the mounting
screws.
|
4. |
Install in the reverse order of removal.
|
Front Driveshaft Components
1. Front driveshaft (LH)
2. Inner shaft bearing bracket
3. Front driveshaft (RH)
[LH]
1. BJ assembly
2. Clip
3. BJ boot band
4. BJ bo ...
Output Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification :
Refer to "Signal Wave Form" section.
...
AC Inverter Oultet Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear console cover.
(Refer to Body - "Console")
...