1. |
Disconnect the negative (-) battery terminal.
|
2. |
Recover the refrigerant with a recover/recycling/charging station.
|
3. |
When the engine is cool, drain the engine coolant from the radiator.
|
4. |
Remove the rear luggage side trim.
(Refer to Body - "Interior Trim")
|
5. |
Remove the blower motor (B) after disconnecting the blower motor
connector (A) and loosening the mounting screws.
|
6. |
Install in the reverse order of removal.
|
Rear Wheel Speed Sensor Removal
4WD only
1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Compressor Components
1. Center Bolt
2. Hub Bolt
3. Hub Assembly
4. Snap Ring
5. Pulley
6. Compressor Assembly
7. Electric Control Valve
...
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cov ...