1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the cowl side trim.
(Refer to Body - "Crash Pad")
|
3. |
Using a screwdriver or remover, remove the crash pad side cover
(A).
|
4. |
Disconnect the stopper (B) from the glove box (A).
|
5. |
Disconnect the air damper (A) from the glove box (B).
|
6. |
Disconnect the pins (A) and then remove the glove box (B).
|
7. |
After loosening the mounting screws, then remove the crash pad
side garnish [RH] (A).
|
8. |
After loosening the mounting screws, then remove the crash pad
under cover (A).
|
9. |
After loosening the mounting screws, then remove the glove box
housing (A).
|
10. |
Disconnect the glove box lamp connector (A).
|
11. |
Disconnect the connector (A) and then remove the intake actuator
(B) after loosening the mounting screws.
|
12. |
Install in the reverse order of removal.
|
Components
1. Camshaft bearing cap
2. Camshaft front bearing cap
3. Exhaust camshaft
4. Intake camshaft
5. Exhaust CVVT assembly
6. Intake CVVT assembly
7. Exhaust camshaft upper ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
...