Kia Sorento: Power Mosfet (DATC) Replacement
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Power Mosfet (DATC) Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the passenger side crash pad under cover (A).
|
| 3. |
Disconnect the connector and then remove the power mosfet (A)
after loosening the mounting screws.
|
| 4. |
Install in the reverse order of removal.
|
Power Mosfet (DATC) Inspection
1.
Measure the resistance between the terminals.
2.
If the measured resistance is not within specification, the blower
resistor must be rep ...
Climate Control Air Filter Description
The climate control air filter is located in the blower unit. It eliminates
foreign materials and odor. The particle filter performs a role as an odor filter
as well as a conventional dust fi ...
See also:
Smart key unit Installation
Smart Key Unit
1.
Install the smart key unit.
2.
Install the smart key unit mounting bolt and nut, and then connect
the connector.
...
Fuel Pump Installation
1.
Install in the reverse order of removal.
Be careful of fuel pump direc ...
Roof Antenna Removal
1.
Remove the rear roof trim.
(Refer to Body - "Roof Trim Assembly")
2.
Disconnect the power cable (A).
...
Copyright В© www.ksmanual.com 2014-2024