1. |
Measure the resistance between the terminals.
|
2. |
The measured resistance is not within specification, the blower
resistor must be replaced. (After removing the resistor)
|
Fuse/relay panel description
Inside the fuse/relay panel covers, you can find the fuse/relay label describing
fuse/relay name and capacity.
✽ NOTICE
Not all fuse panel descriptions in this manual may be applicable to ...
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle. This
is called the GVWR (Gross Veh ...
Installation
1.
Install the back view camera.
2.
Install the tailgate garnish and trim.
...