Kia Sorento: Evaporator Core Replacement - Heater - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Evaporator Core Replacement

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Heater / Evaporator Core Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
3.
Remove the heater unit lower case (A) after loosening the mounting screws.

4.
Pull out the evaporator core (A) from the heater unit.

  
Be careful that the inlet and outlet pipe are not bent during heater core and evaporator core removal/installation.
5.
Install in the reverse order of removal.
A.
If you're installing a new evaporator core, add refrigerant oil (PAG OIL).
B.
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
C.
Immediately after using the oil, replace the cap on the container, and seal it to avoid moisture absorption.
D.
Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
E.
Apply sealant to the grommets.
F.
Make sure that there is no air leakage.
G.
Charge the system and test its performance.
H.
Do not interchange the inlet and outlet heater hoses and install the hose clamps securely.
I.
Refill the cooling system with engine coolant.
Heater Core Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") ...

Temperature Control Actuator Description
The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the proced ...

See also:

Seat belt restraint system
WARNING For maximum restraint system protection, the seat belts must always be used whenever the vehicle is moving. Seat belts are most effective when seatbacks are in the upright position. ...

Sub Frame Removel
1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Specifications
Audio Item Specification Model RADIO/CD/MP3/SDARS (PA30A) RADIO/VCD/MP3/SDARS (BA900) HD RADIO/VCD/MP3/SDARS (BA950) Power supp ...

Copyright В© www.ksmanual.com 2014-2024