1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
|
3. |
Remove the heater unit lower case (A) after loosening the mounting
screws.
|
4. |
Remove the evaporator sensor (A).
|
5. |
Install in the reverse order of removal.
|
Drive Plate Removal and Installation
1.
Remove the automatic transaxle .
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate ( ...
Starter Removal
1.
Disconnect the battery negative terminal.
2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - &quo ...
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp for a bulb check.
The l ...