1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the evaporator temperature sensor connector.
|
3. |
Measure resistance between terminal “+” and “-” of the evaporator
temperature sensor.
Specification
|
4. |
Connect the evaporator temperature sensor connector.
|
5. |
Run the engine and turn the A/C switch ON, then measure the voltage
between the terminals of the harness connector.
|
Input Speed Sensor Specifications
▷ Type: Hall effect sensor
Operation condition (°C)°F
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(0.95 ~ 1.55) 0.950 ~ 1.55
Output voltage ...
Cruise Control Switch Removal
1.
Disconnect the battery (-) terminal.
2.
Remove the air-bag module from the steering wheel. ( Refer to
RT group)
3.
...
Special Service Tools
Tools
(Number and name)
Illustration
Use
09431-45100
Oil seal installer
Installation of transfer case oil seal.
(Right side)
...