Kia Sorento: A/C Pressure Transducer Replacement - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2024 Service ManualKia Sorento: A/C Pressure Transducer Replacement

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / A/C Pressure Transducer Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
Disconnect the A/C pressure transducer connector (A).

4.
Remove the A/C pressure transducer (A).

Tightening torque :
10 ~ 12 N.m (1.0 ~ 1.2 kgf.m, 7.4 ~ 8.8 lb-ft)

  
Be careful not to bend the liquid & suction pipe.
5.
Install in the reverse order of removal.

  
When installing, replace it with a new O-ring (A).
A/C Pressure Transducer Inspection
1. Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”. 2. Inspect the volt ...

Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling ...

See also:

Troubleshooting
Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel b ...

Removal
1. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") 2. Remove the battery and the battery tray. ...

Heated Steering wheel Description
Heated pads to grip the steering grip makes the fever. 1. Heated control unit 2. Heated pad Specifications ...

Copyright © www.ksmanual.com 2014-2024