1. |
Check the condenser fins for clogging and damage. If clogged,
clean them with water, and blow them with compressed air. If bent, gently
bend them using a screwdriver or pliers.
|
2. |
Check the condenser connections for leakage, and repair or replace
it, if required.
|
Piston and Connecting Rod Inspection
Connecting Rod
1.
Check the connecting rod end play.
Using a feeler gauge, measure the end play while moving the connecting
rod back and forth.
...
In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel.
The sensor contains a thermistor which measures the temperature of the
inside. The signal decided by the resistance ...
Starter Inspection
Starter Solenoid Inspection
1.
Disconnect the lead wire from the M-terminal of solenoid switch.
2.
Connect the battery as shown. If ...