1. |
If the compressor is marginally operable, run the engine at idle
speed, and let the air conditioning work for a few minutes, then shut
the engine off.
|
2. |
Disconnect the negative (-) battery terminal.
|
3. |
Recover the refrigerant with a recovery/charging station.
|
4. |
Remove the engine room under cover by loosening the mounting clip
(A) and bolts (B).
|
5. |
Separate the front portion of the front wheel guard from the wheel
base.
(Refer to Body - "Body Side Moldings")
|
6. |
Remove the engine room right side cover.
|
7. |
Loosen the drive belt.
(Refer to Engine Mechanical System - "Drive Belt")
|
8. |
Remove the bolts, then disconnect the suction line (A) and discharge
line (B) from the compressor.
|
9. |
Disconnect the compressor switch connector.
|
10. |
Remove the compressor by loosening the mounting bolts.
|
CVVT & Camshaft Installation
1.
Install the intakeCVVT assembly(A), exhaust CVVT assembly(B) and camshaft(C).
Tightening torque :
53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39 ...
Inspection
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
...
AVN Head Unit Installation
1.
Connect the AVN head unit connectors and cable.
2.
Install the AVN head unit.
3.
Install the center air vent ...