Kia Sorento: Component Location
| [Engine Room] |
| 1. Receiver-drier 2. Condenser 3. Ambient temperature Sensor 4. Compressor 5. Discharge Hose |
6. Suction & Liquid Tube Assembly 7. Service Port (Low Pressure) 8. Service Port (High Pressure) 9. A/C Pressure Transducer 10. Expansion Valve |
| [Interior] |
| 1. In-car sensor 2. Heater & A/C Control Unit (Manual) 3. Heater & A/C Control Unit (DATC) |
4. Photo Sensor 5. Heater & Blower Unit |
Refrigerant Recovery
Use only service equipment that is U.L-listed and is certified to meet
the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning
system.
...
Compressor Oil Specification
1.
The HFC-134a system requires synthetic (PAG) compressor oil whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
...
See also:
Operating door locks from outside the vehicle
Turn the key clockwise to unlock and counterclockwise to lock.
If you lock the driver’s door with a key, all vehicle doors will lock automatically.
From the driver’s door, turn the key to ...
Rear Coil Spring Inspection
1.
Check the spring for distortion, aging or damage.
2.
Check the spring upper pad and lower pad for aging or damage.
...
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...
Copyright © www.ksmanual.com 2014-2024