1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear bumper.
(Refer to Body - "Rear Bumper")
|
3. |
Remove the BSD unit (A) after loosening the mounting screws.
|
Heater & A/C Control Unit (DATC) Self Diagnosis
1.
Self-diagnosis process
2.
How to read self-diagnostic code
After the display panel blinks three times every 0.5 second, the
...
Fuel Tank Air Filter Installation
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped.
In this case, u ...
Front Door Replacement
Front Door Trim Replacement
•
When prying with a flat-tipped screwdriver, wrap it with
...