1. |
Install the key lock cylinder.
|
2. |
Install the illumination bulb, lens and cover.
|
3. |
Install the key warning and immobilizer connector.
|
4. |
Install the ignition switch.
|
5. |
Install the steering column shrouds and crash pad lower panel.
|
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Canister Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Lift the vehicle.
3.
D ...
Specification
Accelerator
Position
Output Voltage (V)
APS1
APS2
C.T
0.7 ~ 0.8
0.275 ~ 0.475
W.O.T
3.8 ~ 4.4
1.75 ~ 2.35
...