1. |
Disconnect the ignition switch connector (B) and key warning switch
connector (A) from under the steering column.
|
2. |
Check for continuity between the terminals.
|
3. |
If continuity is not specified, replace the switch.
|
Photo Sensor Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lam ...
Removal
1.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
2.
Remove the battery and the battery tray.
...
Erasing programmed HomeLink buttons
To erase the three programmed buttons (individual buttons cannot be erased):
Press and hold the left and center buttons simultaneously, until the indicator
light begins to flash (approximately 20 ...