1. |
Disconnect the negative (-) battery terminal.
[Outside]
|
2. |
Loose the screws (2EA) holding the rear combination lamp then
disconnect the connector (A) then remove the outside rear combination
lamp (B).
|
3. |
Replace the bulbs (B) after removing the rear combination lamp
assembly (A).
[Inside]
|
4. |
If the bulbs should be only replaced without removing lamp assembly,
replace the bulbs after removing the rear combination lamp cover inside
trunk.
|
5. |
Remove the tail gate service covers (A) when removing the inside
rear combination lamp assembly.
|
6. |
Disconnect the lamp cover on tailgate. Remove the lamp assembly
(A) after loosening nuts (3EA) and disconnecting the connector.
|
7. |
Remove the tailgate combination lamp assembly (A) and then replace
the bulbs (B).
|
8. |
If the bulbs should be only replaced without removing lamp assembly,
replace the bulbs after removing the tailgate lamp cover inside trunk.
|
Interior A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Cooling Fan Control Module Circuit Diagram
...
Blower Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
...