1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the mounting screws (2EA).
And then remove the overhead console (A).
|
3. |
Remove the overhead console lamp (B) from the head lining after
disconnecting the sunroof switch connector and map lamp switch connector
(A).
|
4. |
If the bulb only should be replaced, replace the bulb after removing
the lens.
|
Brake Pedal Installation
1.
Pre-tighten the bracket fixing bolt (A) in dash panel.
2.
Install the brake booster and brake pedal member fixing nuts (A)
secur ...
Rear Cross Member
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed.
...