1. |
Disconnect the negative (-) battery terminal.
|
2. |
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver
then replace the bulb.
|
3. |
Loosen the fixing screw (2EA) and disconnect the 4P connector.
And then remove the room lamp assembly (A).
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver
then replace the bulb (B).
|
3. |
If it is necessary to replace the lamp assembly, remove the room
lamp (A).
|
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
➀ BSD ...
Description
System Operation
Typically, lane departure warning is activated at a speed over 60 km,
but suppressed in case of unintentional lane departure when driver do not operate
turn signal.
S ...
Air Ventilation Seat Control Unit Installation
1.
Install the air ventilation seat control unit and connector.
...