1. |
Close the panorama sunroof glass and blind completely (Full close
position).
|
2. |
Disconnect the negative (-) battery terminal.
|
3. |
Remove the roof trim assembly.
(Refer to Body - "Roof Trim")
|
4. |
Remove the panorama sunroof glass motor (A) after loosening the
screws and disconnecting the connector.
|
5. |
Check the wiring connector of the panorama sunroof glass motor
as below table.
|
6. |
Remove the blind motor (A) after loosening the screws and disconnecting
the connector.
|
7. |
Check the wiring connector of the blind motor as below table.
|
8. |
Connect the panorama sunroof glass and blind motor and each connectors.
|
9. |
Connect the negative (-) battery terminal.
|
10. |
Start the vehicle engine.
|
11. |
Check the motor's operation by pressing the panorama sunroof switch.
|
12. |
Pless the auto close switch after checking the motor's operation.
|
13. |
Install the panorama sunroof glass motor and blind motor. And
then perform the resetting procedure of the panorama sunroof.
|
Air bag
(1) Driver’s front air bag
(2) Passenger’s front air bag
(3) Side air bag
(4) Curtain air bag
WARNING
Even in vehicles with air bags, you and your passengers must always wear the
safety be ...
Interior Trim Components
1. Front pillar trim
2. Center pillar lower trim
3. Center pillar upper trim
4. Front door scuff trim
5. Rear door scuff trim
6. Cowlside trim
7. Rear pillar trim
8 ...
Brake Line Removal
1.
Disconnect the brake fiuid level switch connector, and remove
the reservoir cap.
2.
Remove the brake fluid from the master cylinder rese ...