Kia Sorento: Rear Washer Motor Inspection
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Washer Motor Inspection
| 1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front bumper")
|
| 3. |
Connect positive (+) and negative (-) battery cables to terminals
3 and 2 respectively to see that the washer motor runs and water is
pumped.
|
| 4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
[Front & Rear washer]
1. Windshield washer (+)
2. Ground
3. Rear washer (+)
|
Rear Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Rear Wiper Switch
Rear Washer Swi ...
See also:
Piston and Connecting Rod Disassembly
•
Use fender covers to avoid damaging painted surfaces.
•
...
Service Standard
Item
Specification
Ignition Timing (°)
BTDC 6 ± 10
Idle Speed (rpm)
A/C OFF
Neutral, N, P-range
680 ± 100
D-range
...
Rear Hub - Carrier Removal
1.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Copyright © www.ksmanual.com 2014-2024