Kia Sorento: Rear Washer Switch Inspection

Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch.

Rear Wiper Motor Installation

1. Install the rear wiper motor assembly. Tightening torque Nut : 7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5 ~ 7.9 lbf-ft) ...

Rear Washer Motor Inspection

1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.    ...

See also:

Occupant Detection system (ODS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front passenger seat ass ...

Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fr ...

SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new one, MUST perform the “Variant Coding” procedure.    1. ...