1. |
Remove the 4P connector from the rear wiper motor.
|
2. |
Connect battery positive (+) and negative (-) cables to terminals
3 and 4 respectively.
|
3. |
Check that the motor operates normally. Replace the motor if it
operates abnormally.
1. IGN +
2. Parking
3. Switch
4. Ground
|
1. |
Operate the motor at low speed using the stalk control.
|
2. |
Stop the motor operation anywhere except at the off position by
disconnecting terminal 3.
|
3. |
Connect terminals 2 and 3.
|
4. |
Connect the positive (+) lead from the battery to terminal 1 and
the negative (-) lead to terminal 4.
|
5. |
Check that the motor stops running at the off position.
|
Line Pressure Control Solenoid Valve
line pressure control solenoid valve is attached to the valve body. This
variable force solenoid valve directly controls the hydraulic pressure inside
the line pressure.
...
Important Safety Notice
Proper service methods and repair procedures are essential for safe, reliable operation
of all motor vehicles as well as personal safety of the operator. The service procedures
and descriptions in ...
IMS Power Seat Control Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...