Wiper Switch
Washer Switch
Rear Wiper Switch
Rear Washer Switch
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")
|
3. |
Remove the side garnish (A) after loosening the screws.
|
4. |
Remove the head lamp washer switch (A).
|
5. |
Make sure that the continuity exists between the terminals as
below. If it is not normal condition, replace the head lamp washer switch
|
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below and if abnormal symp ...
Anti-Pinch Strip Removal
1.
Disconnect the negative (-) battery terminal.
2.
After loosening the mounting screws, then remove the tailgate
side trim (A).
(R ...
Engine And Transmission Assembly Removal
•
Use fender covers to avoid damaging painted surfaces.
•
...