1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the driver door module.
(Refer to Body - "Front door")
|
3. |
Disconnect the connector from the mirror.
|
4. |
Verify that the mirror operates properly as shown in the table.
Mirror Heater
Turn Signal Lamp
BSD Warning Lamp
Mirror Folding
|
Curtain Airbag (CAB) Module Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
Inspection (With GDS)
1.
Check IPM input/output specification of multifunction switch using
the GDS. If the specification is abnormal, replace the lamp or wiper
switch.
...
Direct Electro Hydraulic Actuator Coupling Inspection
All units are filled up with coupling fluid (ultra-low viscosity
ATF) prior to shipping. Inspection, fill-up, and replac ...