1. |
Remove the front door trim.
(Refer to Body - "Front door")
|
2. |
Remove the front door module.
(Refer to Body - "Front door")
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the rear door trim.
(Refer to Body - "Rear door")
|
2. |
Remove the rear door module.
(Refer to Body - "Rear door")
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate")
|
2. |
Disconnect the 4P connector from the actuator.
|
3. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the front door trim.
(Refer to Body - "Front door")
|
2. |
Remove the front door module.
(Refer to Body - "Front door")
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table.
|
1. |
Remove the rear door trim.
(Refer to Body - "Rear door")
|
2. |
Remove the rear door module.
(Refer to Body - "Rear door")
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check for continuity between the terminals in each switch position
according to the table.
|
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate")
|
2. |
Disconnect the 4P connector from the actuator.
|
3. |
Check for continuity between the terminals in each switch position
according to the table.
|
Brake Pedal Inspection
1.
Check the bushing for wear.
2.
Check the brake pedal for bending or twisting.
3.
Check the brake pedal retur ...
Water pump Removal and Installation
1.
Loosen the drain plug, and then drain the engine coolant.
Remove the radiator cap to help drain the coolant faster.
2.
Remove the dr ...
Antenna Coil Installation
1.
Install the coil antenna and connect the 6P connector.
2.
Install the steering column upper and lower shrouds.
...