1. |
There should be continuity between the No.1 and No.3 terminals
when power and ground are connected to the No.2 and No.10 in the ICM-A.
|
1. |
There should be continuity between the No.16 and No.15 terminals
when power and ground are connected to the No.13 and No.14 in the ICM-A.
|
1. |
There should be continuity between the No.8 and No.20 terminals
when power and ground are connected to the No.13 and No.12 in the ICM-A.
|
1. |
There should be continuity between the No.19 and No.7 terminals
when power and ground are connected to the No.13 and No.11 in the ICM-B.
|
1. |
There should be continuity between the No.12 and No.22 terminals
when power and ground are connected to the No.21 and No.22 in the ICM-B.
|
1. |
There should be continuity between the No.17 and No.4 terminals
int the ICM-A when power and ground are connected to the No.2 and No.1
in the ICM-B.
|
1. |
There should be continuity between the No.20 and No.16 terminals
when power and ground are connected to the No.17 and No.6 in the ICM-B.
|
1. |
There should be continuity between the No.15 and No.13 terminals
when power and ground are connected to the No.5 and No.9 in the ICM-B.
|
1. |
There should be continuity between the No.6 and No.18 terminals
in the ICM-A when power and ground are connected to the No.4 and No.3
in the ICM-B.
|
Side Airbag (SAB) Module Components
...
Parking Assist Sensor Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
...
Limp Home Function
1.
Limp Home By Tester
If the PCM(ECM) detects the fault of the SMARTRA or transponder,
the PCM(ECM) will allow limp home function of the immobilizer. Limp
hom ...