1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")
|
3. |
Remove IPM(Intelligent intergrated Platform Module) connector
(A), bolts and nut.
|
4. |
Remove IPM after removing rear connectors.
|
Component Location (2)
1. Door outside handle button
2. Door outside handle
3. Bumper antenna
4. Tailgate switch
...
Compressor Oil Specification
1.
The HFC-134a system requires synthetic (PAG) compressor oil whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
...
Water Temperature Control Assembly Components
1. O-ring
2. Water temperature control assembly
3. Water inlet fitting
4. Engine coolant temperature sensor
5. Thermostat
6. Thermostat gasket
7. Oil cooler coolant ho ...