1. |
Disconnect the negative (-) battery terminal.
|
2. |
Pull out the relay from the engine compartment relay box.
|
1. |
There should be continuity between the No.30 and No.87 terminals
when power and ground are connected to the No.85 and No.86 terminals.
|
2. |
There should be no continuity between the No.30 and No.87 terminals
when power is disconnected.
|
1. |
There should be continuity between the No.30 and No.87 terminals
when power and ground are connected to the No.85 and No.86 terminals.
|
2. |
There should be continuity between the No.30 and No.87a terminals
when power is disconnected.
|
3. |
There should be no continuity between the No.30 and No.87 termianls
when power is disconnected.
|
1. |
There should be continuity between the No.30 and No.87 terminals
when power and ground are connected to the No.85 and No.86 terminals.
|
2. |
There should be no continuity between the No.30 and No.87 terminals
when power is disconnected.
|
1. |
Be sure there is no play in the fuse holders, and that the fuses
are held securely.
|
2. |
Are the fuse capacities for each circuit correct?
|
3. |
Are there any blown fuses?
If a fuse is to be replaced, be sure to use a new fuse of the
same capacity. Always determine why the fuse blew first and completely
eliminate the problem before installing a new fuse.
|
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Push 3 hooks in the engine room relay box out to the arrow direction
and put up the EMS box assembly (A).
|
3. |
Disconnect the connector and remove the EMS box assembly (A).
|
Passenger Airbag (PAB) Module Components
...
Smart Key
Smart Key Code Saving
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
...
Blind Spot Detection Switch Inspection
1.
Disconnect the BSD switch connector.
2.
Operate the BSD switch, then check for continuity between terminals
of BSD switch connec ...