1. |
Operate the seat warmer after connecting the connector, and then
check the thermostat by measuring the temperature of seat surface.
|
2. |
Disconnect the connectors to check for continuity and measure
the resistance between terminals.
|
3. |
Measure the resistance between A1 and B1 terminals of seat cushion.
|
4. |
Measure the resistance between C1 and C2 terminals of seat back.
|
5. |
To measure the resistance of seat back and cushion, connect the
B and C connectors.
Measure the resistance between A1 and C1 terminals of seat.
|
1. |
Operate the seat warmer after connecting the connector, and then
check the thermostat by measuring the temperature of seat surface.
|
2. |
Measure the resistance between 1 and 3 terminals of seat cushion.
[Rear RH seat]
[Rear LH seat]
|
ATF Warmer Component
1. ATF Warmar
2. Bypass valve
3. ATF hose & pipe
4. Coolant hose & pipe
...
SRS Control Module (SRSCM) Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Drive Plate Removal and Installation
1.
Remove the automatic transaxle .
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate ( ...