System Outline |
1. |
IGN2
IGN switch input is determined by Local switch “IGN2”.
|
2. |
SEAT MANUAL switch : SEAT Input
|
3. |
SEAT position Sensor (pulse Signal)
Sensing movement amount of Slide, Recline, Front rear height,
and Rear right height motor
|
4. |
“P” Position switch
Sensing “P” position of SHIFT LEVER, not allowed for memory saving
and easy access function by getting on and off a vehicle in the position
other than “P.”
|
5. |
Dr Door switch
This signal is receiver for sensing state of dr door open state
by BCM.
|
6. |
BCM KEY IN
This signal is received for sensing state of KEY by BCM
|
7. |
Local KEY IN switch
This signal is receiver for sensing state of KEY IN state by BCM.
|
8. |
Speed
This signal is received for sensing vehicle speed by BCM
|
9. |
IMS switch
|
10. |
LIN Communication LINE
|
1. |
Input switch - 40ms delay
SLIDE, RECLINE, Front rear height, rear right HEIGHT switch
“P” Position switch, SPEED, KEY IN, LOCAL KEY IN switch, DR DOOR
switch, IGN2 switch
|
2. |
IGN switch input is determined by Local switch “IGN2.
|
1. |
±10%, for TIME without error indication
±50ms, for TIME not exceeding 500ms
|
2. |
Indicated time in each function does not include Time of controlling
CHATTERING started from changing point of rr input.
|
Emergency Fastening Device (EFD) Description
Emergency Fastening Device (EFD) operates as well as Belt Pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on driver and pass ...
Room Lamp Installation
1.
Install the room lamp assembly after connecting the lamp connector.
2.
Install the lamp lens after assembling the bulb.
...
Troubleshooting, Customer Complaint Analysis Check Sheet
There are six areas where a problem can occur: wiring harness, the radio,
the CD player, and speaker. Troubleshooting enables you to confine the problem
to a particular area.
Chart 1 ...