1. |
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
|
2. |
Select the vehicle model and then do "CODE SAVING"
|
3. |
After selecting "CODE SAVING" menu, button "ENTER" key, then the
screen will be shown as below.
|
4. |
After removing the ignition key from key cylinder, push "ENTER"
key to proceed to the next mode for code saving. Follow steps 1 to 4
and then code saving is completed.
|
Water Temperature Control Assembly Removal
1.
Disconnect the battery negative terminal.
2.
Loosen the drain plug and drain the engine coolant.
3.
Remove ...
Seat Heater Switch Inspection
Front Seat Heater Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel (A).
(Refer to Body - &q ...
Specifications
Item
Specifications
Transaxle type
A6LF2
Engine model
Gasoline 3.3 GDI
Torque converter type
3-element, 1-stage, 2 ...