1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the glove box housing (A).
(Refer to Body - "Crash pad")
|
3. |
Remove the smart key unit (A) after removing the bolts and connectors.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the console assembly (A).
(Refer to Body - "Console")
|
3. |
After loosening the antenna bolts (2EA) and connector, remove
the interior 1 antenna (A).
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the floor console rear cover (A).
(Refer to Body - "Console")
|
3. |
After loosening the antenna nuts (2EA) and connector, remove the
interior 2 antenna (A).
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
After loosening the mounting bolts, then remove the third seat
assembly (A).
(Refer to Body - "Rear seat")
|
3. |
After loosening the antenna nuts (2EA) and connector (A), remove
the interior 3 antenna (B).
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear bumper.
(Refer to Body - "Rear bumper")
|
3. |
Disconnect the antenna connector (A) on the center of rear bumper.
|
4. |
After loosening the screws (2EA), remove the exterior bumper antenna
(A).
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front left wheel guide.
|
3. |
Disconnect the connectors, then remove the buzzer (A).
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Disconnect the connector after removing the door trim.
(Refer to Body - "Front door")
|
3. |
After loosening the mounting bolt, then remove the key holder
(A).
|
4. |
Remove the outside handle (A) by sliding it rearward.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the tailgate garnish.
(Refer to Body - "Body side molding")
|
3. |
Remove the outside handle panel assembly (A) after removing the
screws and connectors.
|
4. |
Remove the outside handle (A) after removing the screws.
|
ATF Warmer Component Location
1. ATF Warmar
2. Bypass valve
3. ATF hose & pipe
4. Coolant hose & pipe
...
PTG Spindle Installation
1.
Connect the PTG spindle, bracket and connector.
Tightening torque :
6.9 ~ 10.8N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 8.0 lb-ft)
...
Head Lamps Component (1)
1. Head lamp assembly
2. Head lamp high beam bulb
3. Head lamp low beam bulb
4. Dust cap
5. Turn signal lamp socket & bulb
...