Kia Sorento: Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground
the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn Relay Inspection
| 1. |
Remove the horn relay (A) from the engine room relay box.
|
| 2. |
There should be continuity between the No.30 and No.87 terminals
when power and ground are connected to the No.85 and No.86 terminals.
|
| 3. |
There should be no continuity between the No.30 and No.87 terminals
when power is disconnected.
|
Installation
1.
Install the horns after connecting the horn connectors.
2.
Install the head lamp.
(Refer to "Lighting system")
...
Adjustment
1.
Operate the horn, and adjust the tone to a suitable level by turning
the adjusting screw.
...
See also:
Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which would seal the fuel filler. After the
gasket on the fuel filler cap and the fi ...
Fluid Replacement
The ATF of the 6 speed automatic transaxle does not need to be
replaced.If the vehicle is used in severe conditions or b ...
Drive Plate Removal and Installation
1.
Remove the automatic transaxle .
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate ( ...
Copyright В© www.ksmanual.com 2014-2024