1. |
With the multi function switch in each position, make sure that
continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function
switch
Lighting switch (Auto light)
Lighting Switch
Dimmer And Passing Switch
Turn Signal Switch
Front Fog Lamp
|
1. |
With the multi function switch in each position, make sure that
continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function
switch.
Wiper Switch
Washer Switch
Rear Wiper Switch
Rear Washer Switch
|
ECM Terminal And Input/Output signal
ECM Terminal Function
Connector [C300-A]
Pin
No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output
[NON-smart ke ...
Water Temperature Control Assembly Components
1. O-ring
2. Water temperature control assembly
3. Water inlet fitting
4. Engine coolant temperature sensor
5. Thermostat
6. Thermostat gasket
7. Oil cooler coolant ho ...
Interior A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...