Kia Sorento: A/C Pressure Transducer Description

The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed. Engine ECU stops the operation of the compressor when the temperature of refrigerant line is very high or very low irregularly to optimize air conditioning system.

Receiver-Drier Replacement

1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench (A). Tight ...

A/C Pressure Transducer Inspection

1. Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”. 2. Inspect the volt ...

See also:

Starter Inspection
Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

Overhead Console Lamp Installation
1. Install the overhead console lamp after connecting the sunroof switch connector and lamp connector. 2. Install the lens after tightening ...

Seat Belt Pretensioner (BPT) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...