1. |
Install in the reverse order of removal.
|
2. |
Prior to installing a new ECU, upload the original ECU’s clutch
learing to the replacement ECU using the GDS tool.
(Refer to 4WD Control System - "Repair procedures")
|
SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new one, MUST perform the “Variant Coding”
procedure.
1.
...
Rear Hub - Carrier Removal
1.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Oil hydraulic Motor(Actuator) Removal
1.
Remove the coupling assembly.
(Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator
Coupling")
2.
Keep goin ...