Kia Sorento: Windshield Wiper-Washer Switch Installation
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch Installation
| 1. |
Install the windshield wiper switch.
|
| 2. |
Connect the wiper switch connector.
|
| 3. |
Install the steering column upper and lower shrouds.
|
Windshield Wiper-Washer Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after loosening
3 screws.
...
Windshield Wiper-Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer Switch
R ...
See also:
Specifications
Direct control VFS[35R/C]
▷ Control type : Normal high type
Control Pressure kpa
(kgf/cm², psi)
539.370 ~ 0 ( 5.5 ~ 0, 78.23 ~ 0)
Current value(mA) ...
Troubleshooting
Problem
Possible cause
Solution
Not pairing
Bluetooth device of Car is not discoverable mode
Enter Bluetooth pairing (searching) mode
Userâ ...
Seat Belt Pretensioner (BPT) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright © www.ksmanual.com 2014-2026