Kia Sorento: Wheel Repair procedures - Tires/Wheels - Suspension SystemKia Sorento: Wheel Repair procedures

Kia Sorento (MQ4, 2021-2026) Service Manual / Suspension System / Tires/Wheels / Wheel Repair procedures

Removal
1.
Remove the wheel cover (A).
[Front]

Suspension System — Tires/Wheels / Wheel / Repair procedures / Removal illustration

[Rear]

Suspension System — Tires/Wheels / Wheel / Repair procedures / Removal illustration

2.
Remove the wheel and tire (A).

Tightening torque :
107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

[Front]

Suspension System — Tires/Wheels / Wheel / Repair procedures / Removal illustration

[Rear]

Suspension System — Tires/Wheels / Wheel / Repair procedures / Removal illustration

Installation
1.
Install the wheel and tire (A).

Tightening torque :
107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

[Front]

Suspension System — Tires/Wheels / Wheel / Repair procedures / Installation illustration

[Rear]

Suspension System — Tires/Wheels / Wheel / Repair procedures / Installation illustration

2.
Install the wheel cover (A).
[Front]

Suspension System — Tires/Wheels / Wheel / Repair procedures / Installation illustration

[Rear]

Suspension System — Tires/Wheels / Wheel / Repair procedures / Installation illustration

Wheel Run-out Inspection
1.
Jack up the vehicle and support with a jack securely.
2.
Measure the wheel Run-out by using a dial indicator as illustration below.
Limit
Circumferential
Axial
Run-out
Aluminium Wheel
0.3
0.3

Suspension System — Tires/Wheels / Wheel / Repair procedures / Wheel Run-out Inspection illustration

3.
If measured value exceeds the standard value, replace the wheel.
Tire Repair procedures
Tire Wear ...
Wheel Balance Inspection
Inspection Wheel balance needs to be adjusted if the tires are unbalanced or after tire replacement or maintenance work has been performed. Maxim...
See also:

Oil Pan Installation
1. Install the oil pan. (1) Using a gasket scraper, remove all the old sealant material from the gasket surfaces. ...

Compass Mirror Calibration Procedure
If the compass has been calibrated or set to variance zone number incorrectly, or you are driving in specific places (tunnel, parking lot in building, underground parking lot, near transforme ...

EPB malfunction indicator. When the EPB is not released
EPB malfunction indicator If you press the ENGINE START/STOP button in the ON position, and the engine turns OFF after approximately 3 seconds while the system is operating normally, the followi ...

Copyright © www.ksmanual.com 2014-2026 - 0.0639