1. |
Loosen the drain plug, and then drain the engine coolant.
Remove the radiator cap to help drain the coolant faster.
|
2. |
Remove the drive belt after turning the drive belt tensioner counterclockwise.
(Refer to Timing System - "Drive Belt")
|
3. |
Remove the water pump pulley (A).
|
4. |
Remove the water pump sub assembly (A) with the gasket.
|
5. |
Remove the exhaust manifold heat protector.
(Refer to Intake And Exhaust System - "Exhaust Manifold")
|
6. |
Remove the water pump housing (B) with the gasket and the water inlet
pipe (A).
|
7. |
Install in the reverse order of removal with a new water pump gasket.
|
8. |
Fill the engine coolant.
|
9. |
Start the engine and check for leaks.
|
10. |
Recheck the coolant level.
|
Side Impact Sensor (SIS) Installation
Front Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect ...
Rear Driveshaft Inspection
1.
Check the driveshaft boots for damage and deterioration.
2.
Check the ball joint for wear and damage.
3.
Che ...
Blower Motor Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a know ...