Kia Sorento: Towing - General InformationKia Sorento: Towing

Kia Sorento (MQ4, 2021-2026) Service Manual / General Information / Towing

General Information

Towing
Be sure the following below when towing.
Note
•
Avoid towing a vehicle heavier than the vehicle doing the towing.
•
Press the brake pedal hard during braking as the performance may be reduced than usual.
•
As the steering wheel operation may not be usual, so operate stronger than the usual.
•
When driving down a long hill, the brakes may overheat and brake performance will be reduced, therefore stop the vehicle often to cool down the brakes.
•
When towing, passengers need to sit as far as possible from the vehicle except the driver.
•
The side airbags may deploy if the engine start button is 'on', be sure to turn off the vehicle before towing.
Towing hook
Towing hook can be installed at the front and back of the vehicle.
Note
When towing by connecting the towing hook to other part of the vehicle, as it may damage or deform the body of the vehicle.
1.
Remove the cover by pressing the bottom of the hole cover of the bumper.
[Front]

General Information — Towing / General Information illustration

[Rear]

General Information — Towing / General Information illustration

2.
Insert the towing hook by turning it clockwise into the hole until it is fully secured.
[Front]

General Information — Towing / General Information illustration

[Rear]

General Information — Towing / General Information illustration

Note
Before towing, make sure the hook is installed properly.
How to tow with general vehicle
1.
Fasten rope or chain securely to the hook.
Note
Use the rope or chain less than 5 m long, mark in the middle of these for easy visibility.
2.
Put the gear shift lever to N.
3.
Maintain the vehicle at 'ACC' state for steering wheel not to be locked.
4.
Release the parking brake.
5.
The drivers of both vehicles communicate with each other and tow the vehicle.
Note
•
Passengers other than the driver must not be allowed to be on board.
•
The driver must be in the vehicle for steering and braking operations when the vehicle is towed.
•
Steer the steering wheel in the same direction as the tow vehicle.
•
Avoid reckless driving such as sudden start and braking, which may put excessive load on the towing hook, rope or chain.
•
Accelerate or decelerate the vehicle in a slow and gradual manner while maintaining the tension on the tow rope or chain to start or drive the vehicle.
How to tow with tow-truck
These three methods can be used to tow for general vehicles. However, the sling-type towing method is not recommended as it may damage the vehicle except for the emergency situation.
–
Flatbed towing
A method of towing by loading a vehicle behind a tow truck.
It is the safest and best way to tow a full time all wheel drive vehicle.
–
Under lift towing
A method of lifting the drive shaft wheel of the vehicle to the tow truck and making the opposite wheel touch the floor or towing using auxiliary equipment.
* For full time all wheel drive vehicle, be sure to use auxiliary equipment such as dolly to prevent wheels from touching the ground.
–
Sling type towing
A method of towing using a tow truck's hooked chain.
Sling type towing is not recommended as it can seriously damage the vehicle's suspension and body.
Note
•
To prevent the damage of the vehicle, full time all wheel drive vehicles must be towed by flat bed towing method or under lift towing method. When using under lift method, auxiliary equipment such as dolly must be used to prevent wheels from touching the ground.

General Information — Towing / General Information illustration

•
If lifting or towing the vehicle using the bumper may damage the vehicle, so you must use the towing hook to tow the vehicle.
Lift and Support Points
General Information Lift Points and Precautions for Lift Acquaint the following instructions below when using lift. • ...
Warning and Caution Labels
General Information Warning and Caution Labels Cooling Fan Caution Label Pressure Cap Caution Label ...
See also:

Rear Glass Defogger Printed Heater Inspection
   Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on th ...

Mechanism Assembly Repair Procedures
Removal 1. Remove the roof trim. (Refer to Roof Trim - "Roof Trim Assembly") ...

Ladder Frame Removal
   ...

Copyright © www.ksmanual.com 2014-2026 - 0.0579