Kia Sorento: Rear Shock Absorber Repair procedures

Removal

1.	Disconnect the (-) battery terminal.

2.	Remove the rear wheel and tire. (Refer to Tires/Wheels - "Wheel")

Remove the rear shock absorber (A) after removing the bolts.

Tightening torque

Bolt (B) : 117.7 - 137.3 N·m (12.0 - 14.0 kgf·m, 86.8 - 101.3 lb·ft)

Bolt (C) : 156.9 - 176.5 N·m (16.0 - 18.0 kgf·m, 115.7 - 130.2 lb·ft)

Suspension System — Rear Suspension System / Rear Shock Absorber / Repair procedures / Removal illustration

Disassembly

1.	Remove the lock nut cover (A).

Using the special tool (09546-3X100), install the self locking nut.

Suspension System — Rear Suspension System / Rear Shock Absorber / Repair procedures / Disassembly illustration

Do not reuse the self locking nut.

3.	Separate the bracket assembly (A), bumper rubber (B), dust cover (C), shock absorber (D).

Inspection

1.	Check the rubber parts for damage or deterioration.

2.	Check the shock absorber for abnormal resistance or unusual sounds.

Disposal

1.	Fully extend the shock absorber rod.

Drill a hole to remove gas from the cylinder in section (A).

Suspension System — Rear Suspension System / Rear Shock Absorber / Repair procedures / Disposal illustration

•	The gas coming out is harmless, but be careful of chips that may fly when drilling. Be sure to use face shield and safety goggles.

Reassembly

1.	To reassemble, reverse the disassembly procedure.

Installation

1.	Install in the reverse order of removal.

Components and Components Location Components and Components Location [2WD] 1. Rear cross member2. Rear stabilizer bar3. Rear stabilizer ba...

Components 1. Spring upper pad2. Coil spring 3. Spring lower pad...

Manuals list